How to use the SS7 link set 2020-05-25
Technical Guides
How to use the SS7 link set
-
- In some cases, an SS7 trunk may not have a real Signal Link and must therefore share a Single Link from another SS7 trunk. This instruction guide aims to show how to use the SS7 link set. In this guide, the MTG2000 is used as an example to illustrate configurations, and the configurations will also apply to other Dinstar MTG products.
- Note: MTG200/MTG600/MTG1000B do not have this feature.
- Port MTG 0 is connected to a standard SS7 trunk, the SL (Signal link) is in timeslot 16, the OPC/DPC of port 0 is 9311/9315, and the CIC is 1-31, starting from timeslot 1. Port MTG 1 is connected to another SS7 trunk. Since port 1 does not have a real independent SL, it must use the SL of port 0. The OPC/DPC of port 1 is 9299/9294, and the CIC is 1-31, starting from timeslot 1.
Normal SS7 configuration
1. Add the SS7 trunk- Click SS7 → SS7 Trunk, then add a normal SS7 trunk SS7_Normal for port 0 on the page.

The OPC/DPC is 9311/9315 (in DEC format) and must first be converted to HEX format during configuration.
You can use the calculator to change the format.
DEC 9311 → HEX 245F
DEC 9315 → HEX 2463
Note: if your SS7 provider supports the 14‑bit format (3-8-3), you can set the SS7 trunk directly as follows :
2. Add the MTP SS7 link- Click on SS7 → SS7 MTP Link, then add a normal SS7 MTP link No.0 for SS7_Normal on the page.
3. Add the SS7 link set- Click SS7 → SS7 Link Set, then add an SS7 Link Set No.0, which is included in MTP Link No.0.
4. Add the CIC- Click SS7 → SS7 Circuit, then add the CIC information.

Configurations when there is no real SS7 link.
1. Add the SS7 trunk- Click SS7 → SS7 Trunk, then add the SS7 trunk SS7_Logic for port 1, with the link set number configured as Link Set No.0 (defined in previous steps). Since the SS7 trunk on port 1 has no real SL and only a logical SL, it must share the SL of another port via the link set.

Note: the OPC/DPC is 9299/9294 (in Dec format) and must be converted to Hex format
Dec 9299 → Hex 2453
Dec 9294 → Hex 244E
2. Add the MTP SS7 link- Click SS7 → SS7 MTP Link, then add MTP SS7 No.1 link for the port. The link mode is set to Logical.
3. Add the CIC- Click SS7 → SS7 Circuit, then add the CIC information for the two SS7 trunks.

