How to configure voicemail for the DINSTAR IP PBX 2021-12-17

Technical Guides

How to configure voicemail for the DINSTAR IP PBX

  • Voice mail is a key feature for the IPPBX. Sometimes, if you missed the call, the call can be forwarded to voice mail. After a while, you can receive the voice message and call back the person who called you. A few steps are required to configure voice mail support.
    Because storage is very limited with the UC‑120, if you use the UC‑120 to support voicemail, you must connect external storage such as a UDisk(USB hard drive/USB key) or an SD card to record the voice file.
    By default, the SIP phone ring timeout is 50 s; if you want to reduce this delay, you can go to Extension->SIP, modify the Ring timeout if desired.

    VM.png
    As the diagram shows above, if no one answers the call after a certain ring time, the call will be forwarded to voicemail. Then the system will guide you step by step to leave a voice message. Before enabling voicemail, you must configure certain settings for it to work. The steps below guide you through setting up voicemail support.
    1. Enable the mail server, go to System->Email to enter the mail server address and port, and ensure the connection is fully ready.
    2. Configure DNS, verify DNS is set, go to Network->Settings to enter the DNS server address.
    3. Check storage, make sure you have valid storage, go to Profile->Voicemail to select the correct storage.
    4. Enable voicemail, go to Extension->SIP, select Voicemail ENABLED, fill in the email account where you want to receive the voice file.
    5. Check the voicemail from Voicemail Profile->Message List and check your email for the voice file.
    Watch the installation video on YouTube